5501R-5502R 3 Ply Minimum Length Bellows Connector

5501R-5502R 3 Ply Minimum Length Bellows Connector

Information at a Glance

Series

5500 Laminated Bellows Connectors

Material

Steel

Size

2 – 24+ inches /50 – 600 mm
1 – 240+ inches / 25 – 6000 mm

Pressure

≤150 & 300 PSI / 10 & 20 Bar

Motion

1 inch  / 25 mm

Canadian Registration

 

This product is registered throughout Canada under
CRN 0D9278.59870YTNADD3

Other Products

Product Description

  • Sizes 1 1/2″ through 24″
  • Design Conditions: full vacuum to 150 & 300 psig at 500F
  • Compact design with maximum flexibility and extended life
  • Designed specifically to isolate and protect mechanical equipment

Series 5500 Bellows Pump Connectors are designed for installation adjacent to mechanical equipment to isolate vibration, absorb small pipe movements and to provide flexibility during installation. The bellows element is laminated (3 ply minimum) for maximum flexibility and fatigue resistance. Standard configurations include integral full thrust limit rods to react the full pressure thrust or compression for vacuum conditions.

Series 5500 Bellows Pump Connectors installed on the suction and discharge of a pump to absorb motion

Technology & Advantages

Common Applications

Bellows pump connectors are designed to connect rigid piping to mechanical equipment that has thermal growth or mechanical movement. Although limit rods are an integral part of the design to prevent over extension or compression, these rods should be loose for full benefit. The rigid anchor shown in the illustration must be capable of reacting the pressure thrust and the spring force of the bellows.

Design Data

Note:
(1) Overall length is measured from flange face to flange to flange face including the van stone for Type 5502R.
(2) Maximum outside diameter – includes limit rod lug attachments.
(3) Type 5506R is available rated for full vacuum to 150 psig at 500°F as a replacement for rubber expansion joints, nominal sizes 2” through 14”. Sizes 2” through 8” are 6.0” overall length and sizes 10” through 14” are 8” overall length. All other dimensions and performance data are the same as Type 5502R.
Note:
(1) Overall length is measured from flange face to flange to flange face including the van stone for Type 5502R.
(2) Maximum outside diameter – includes limit rod lug attachments.

Ordering Information

  • Refer to Tables 2 and 3 to select the configuration and service conditions required for your application.

Example
6” Bellows Pump Connector at 500°F maximum, 5502R-160 van stone 150 lb. flange both ends, limit rods

5502R: Type specification, van stoned flange limit rods
160: Size & pressure designation, 6″ NPS, 150 PSIG

  • To add an optional flow liner, add an “L” to the type specification i.e. 5501RL or 5502RL

Hyspan products are available from Sales Representatives and Distributors, or they can be purchased direct from the factory. The minimum factory order for open account customers, COD shipments, or bank card sales is $100.00 (USD). All major credit or debit cards are accepted. The minimum order for new account applicants is $100.00. Our Confidential Credit Application can be downloaded and forwarded to Hyspan for processing. All orders are subject to the following Terms and Conditions, and the above warranty applies to all material. Please read these documents.

Terms and Conditions

Confidential Credit Application (13.9 KB), can be completed on line.